Watch for the following in conventionally framed roofs:

  1. Sagging ridge/rafters;
  2. Damaged framing;
  3. Poor design/materials/workmanship;
  4. Adequate wood to wood connections (fit/hardware/fasteners);
  5. Toe-nailed rafter plumb cuts: 3 in one side, 2 in the other;
  6. Proper metal connector fasteners: (tico nails #10 not #8), no 8d checkerhead sinkers/roofing
  7. Nails/screws;
  8. Collar ties: in roof upper 1/3, every other rafter pair (Not needed where metal connectors are used at the rafter/ridge connection. Their purpose is to resist uplift;
  9. Rafter ties: as low as possible, every other rafter pair;
  10. 5-16d nails through the tie into the rafter;
  11. Rafter ties continuous across the attic;
  12. Purlin braces: bear on walls, not ceiling joists; or
  13. If purlin braces bear on strongbacks (or ceiling joists), check for ceiling sag

 

Metal Connectors and their Fasteners:

  1. Fasteners for almost all single metal connectors will be minimum 10d nails with the number marked on the nailhead (not 8d).
  2. Fasteners for almost all double and triple metal connectors will be minimum 16d vinyl-coated checkerhead nails.
  3. When hangers do not support top chords laterally, i-joists require web stiffeners to be installed.

 

Are Ridge Boards Necessary?

Conventional Ridge

Ridge boards are an advantage with modern OSB or plywood panel sheathing but are less important on older roofs with wood board sheathing.

On roofs with modern panel sheathing, the sheathing on a single slope acts to a great extent as a single diaphragm. Backing for perimeter nailing is provided by sub-fascia at the eaves, by common, hip, or valley rafters at the gables, hips, or valleys, and at the peak, backing is provided by the ridge board.

On older roofs with wood boards used as sheathing, the sheathing acts less as a diaphragm, and so perimeter nailing is less important. On these houses, the ridge is often 1x6 and its main purpose is to provide backing for nailing rafters, especially if rafters on opposite sides of the ridge to not exactly oppose.

 

Why Rafters Pairs Should Oppose

Opposing rafters form pairs that need to have their bottoms tied together in order to form a simple triangular truss. To be structurally efficient and allow rafter ties to effectively connect their bases, rafters need to oppose each other as directly as possible.

Structural Ridges

In homes with cathedral/vaulted ceilings that have no rafter ties, the ridge must be strong enough to support the roof load without sagging. A structural ridge is used for this purpose. Structural ridges are typically wood or steel beams. Solid wood beams may be used, they may consist of  layers of engineered lumber bolted (LVL or “MicroLam”)or glued (GluLam) together to form a beam.  Structural ridges are typically supported at each end by posts. When roofs have long spans, intermediate posts may also be used.

 

 Collar Ties VS Rafter Ties:

COLLAR TIES are not required in all roofs, only roofs for which they have been specified by an architect or structural engineer. Roofs with no collar ties installed are not deficient. Where they are required, they are usually 1x6 or 2x4, typically installed every other rafter pair (4'oc), in the upper third of the roof. 5 nails per side.

 

RAFTER TIES are required on all conventionally framed roofs unless a structural ridge is installed. They should be installed as low as possible in the roof. Min. per side: 5 face nails into the rafter and 1 toenail into the top plate (when possible).